Sunday, October 9, 2011

Underhood inspection

Now that the emissions is done, you may begin the full safety inspection. Inspect the wiper blades for tears then open the hood. Make sure the battery is safely secured and held down tight. While you'reunder the hood, take a look at the belts and check the engine fluids and note down any problems you may find. Also check for the emissions components under the hood such as the pcv valve, air pump (if originally equipped), the EVAP canister and any broken vacuum lines. A loose battery hold down or torn wipers will fail the safety inspection. Also if the hood latching mechanism is not working properly, this will fail safety too. Remember, even though a car may have passed the emissions test, missing or incorrectly emissions components will fail the safety inspection.

Emissions testing

DLC connector
It is now time to perform the emissions test. After entering your drivers license number into the emissions machine, the machine will tell you to scan the vehicle registration. This is why you verified its expiration date in the first step. From there follow the directions on the screen. It will have you enter the vehicle year, make, model, transmission type, registration county and GVWR (gross vehicle weight rating) if its a truck or minivan. Then you will have to perform the gas cap test. Connect the gas cap to the proper adapter located by the testing machine then connect the emissions air hose. begin the test and the machine will apply a set pressure to the gas cap to ensure it isn't leaking. When that is finished, connect the DLC(data link connector) to the DLC in the vehicle. This is the rectangular connector usually located on the driver side foot well, but some European cars have them on the passenger side or integrated into the center console. Start the car and press enter to begin the test and the machine will scan the car for any problems while it is idling. If all goes well, the test will be over in less than a minute and you will start writing the emissions sticker.

Exterior check

Upon pulling the vehicle back into the shop after the test drive, honk the horn to make sure it works and have a fellow employee assist in verifying all exterior lights are in working order. Any light that doesnt turn on when commanded to fails for the safety inspection. Be sure there arent any aftermarket equipment in front of any of the lights for this is grounds for a failuer and will require removal of the part prior to affixing a safety sticker. Broken lenses, missing lenses or cracked lenses will need replacing before a vehicle can pass the inspection. During the light check, walk around the car and check for any body damage or protruding body parts. Body damage may fail depending on the extent of said damage. If a bumper is just hanging on or flopping around or has sharp corners sticking out, that is considered a hazard and will fail.


Thursday, September 15, 2011

Paperwork Verification

The first step before even getting in the car is making sure the registration and insurance is valid and is the correct one for the car you are going to work on. The paperwork must be valid prior to any testing because expiration dates are sent to the dmv through the emissions machine, and the state inspection record booklet. Verify that the VIN on the paperwork matches the VIN located on the lower left hand of the vehicles windshield. If so you may begin the second part of the inspection procedure.

Interior Inspection & Test Drive

Once inside the car check all of the mirrors for cracks and discolorations, and make sure the windshield wipers work properly and do not leave streaks. Windshield cracks can fail the safety inspection along with broken/missing door handles and non working window switches. The horn must also work and be easily audible. The interior check out  should take less than a minute. Now take the car out on the open road and see how the steering, brakes, and suspension feels. Listen for suspension and brake noise while driving. Also, if traffic permits, brake hard from a decent speed and feel for a brake shimmy or vehicle pull. This will give you tips on things to look for when you have the wheels off.